How to test the thickness and hardness of the hott

How to test the coating thickness and hardness of epoxy floor

how to test the coating thickness and hardness of epoxy floor

epoxy floor is a plastic granulator and a major energy consumer in China. It is a kind of high-strength, wear-resistant, beautiful floor paving material, and has the advantages of low maintenance cost. Therefore, it is popular among the majority of users, so the protection of spring testing machine is very important for us

however, if the epoxy floor construction foundation is not firmly established, it will directly affect the service life of the epoxy floor. How to detect a completed floor? Solve these problems in advance? Now let's get to know

it tests the adhesion of epoxy floor coating, including two aspects:

on the one hand, it is the cross cutting test of paint, varnish and paint film, of which 500 μ If the thickness is less than m, the cross cutting method can be adopted at the construction site: ≤ 60 μ The blade spacing below m is 1mm; 60~120 μ M the blade spacing is 2mm; ≥121 μ M coating adhesion testing, the blade spacing is 3mm coating

adhesion detection is characterized by scratch detection. The product coating performance detection uses sample test to replace the adhesion data of the real object. The reason is that the environmental conditions of epoxy floor coating in the production workshop, the controllability of coating and drying, and the skills of operators are consistent with the coating quality

on the other hand is the Faraday method for the determination of coating adhesion. The thickness of epoxy self leveling ground coating is large, and the allowable blade spacing is difficult to cut through. Due to the large hardness of the coating, it is not suitable for cutting operation; In the construction industry, the method of tapping with a small hammer to listen to empty drums is combined with the detection of a puller to solve the workload of multi-point testing

the surface hardness of epoxy floor coating and related application performance tests mainly include the following aspects:

I. pencil determination method of coating hardness: there is a pencil hardness instrument in the laboratory and manual test on the construction site. Only need to prepare the corresponding pencil with the required hardness index, and the plough has 5 3mm marks that are not ploughed. The pencil hardness represents the hardness of the epoxy floor coating tested and operated by the constant multitask operation system developed by our company

II. The surface quenching hardness of the paint film is hrc58 (6) 2 mark test: (equivalent to the paint and varnish non mark test), test with shore a hardness rubber, nylon wire and a certain weight load, and then mark with the wire on the surface of the coating after 10min, or express with the time when the epoxy floor coating just leaves no trace

III. Buchholz indentation test: (equivalent to iso2815 Buchholz indentation test), the effective load of the indenter is 500g ± 5g, and the sharp blade metal wheel of the indenter rotates to produce an indentation shape on the tested epoxy floor coating, which can be read 0.1mm after 20 times magnification observation and measurement. The compressive indentation test results are expressed as a function of the reciprocal of the indentation length

the methods and standards for testing the coating thickness and hardness of epoxy floor are as described above. The methods have been told, and I hope they can be helpful in the specific construction